Product Specification: Dimension: 95mm(L)*65mm(W)*59mm(H)
Weight: 43g
Material: PC
Support Cameras: GoPro Hero6/5, Hero4 Black/Silver, Hero3+
Installation & Operation: 1, Instal the support holder on the tripod and tighten it.
2, Insert the GoPro camera into the camera support.
3, Put the camera support onto the support holder. Take pictures by remote. After one shot pull out the camera support and rotate 60 degree and put it onto the support holder again. Then shot by remote again. Repeat such operation for 6 times.
4, Insert the camera again into the camera support in another direction.
5, Put the camera support on the support holder again. Repeat the step3 and take 6 pictures by remote. 12 pictures have to be taken together.
Note: 1, Backing Board for GoPro3+/4
Because the camera size of GoPro3+/4 is smaller, so it needs the backing board. With the backing board the camera size of GoPro3+/4 is the same as the GoPro5/6. So the camera support can also be used for GoPro3/4.
2, For different battery, the camera thickness will change. If with the backing board, it still have wide gap in the camera support, please use the rubber pad to fix the gap.
Packing List: Camera Support *1 Support Holder *1
Backing Board for GoPro3+/4 *1
User Manual *1
Attention: 1, Please use the camera support in normal condition, avoid low and high temperature. avoid corruption, clean it by water.
2, Be sure the support is instaled stable on the tripod, avoid strong wind.
3, Do not tilt.
4, Keep it safety, prevent the children from swallowing.
